OWL Division meet in Löhne, Germany. "Mr. Dave" George, Larry Donsbach and Jeff Merrill
Cut the ends open. 50' ramp. Autoracks are 2 level versions. long, 7' wide. -We Honest- cars
Inside of open end. Plastic is thick in the corner so deeper cuts here.
Cut the bottom about the thickness of the door. CUT AT AN ARC, like the door. Plastic is thick. Use a #11 thinner blade to mininize distortion...
Cut the ends open. Plastic is thick. Use a #11 thinner blade to mininize distortion from digging so deep. #24 blade is too thick. Plastic is...
AZL Autoracks coupled (stretched). Scale 4 feet, 8 inches. 4 feet when compressed.
A top view of AZL's 89' foot Autoracks on 14 and 17 inch radius. 9 cars are needed on the 14 inch and 11 cars on the 17 inch to make a full...
AZL's Autotracks compared to AZL High Cubes.
AZL's Autotrack AutoLatch (SM) coupler hang. 4 feet when cars are compressed, 4 feet 8 inches when pulling. Sweet.
AZL's Autotracks end detail !
AZL's Autotracks in their new home. Several more sets are due to fill out this unloading site (note hundreds of the 'We Honest' cars in the bags...
AZL's Autotracks compared to MTL and FR Well cars.
AZL Autoracks on 14 inch (35cm) and 17" (43cm) radius views. 9 cars to make a semi-circle on the 14", 11 cars would make the...
Bottom view of Rob Ray's Rob Ray's new Pair-o-dice module
The BAZ BoyZ use the Z-Bend Track module standard. Since we run DCC and have both long runs, Tee's and Wyes plus LOTS of turnouts and Accessories...
Jeff Merrill laid all the MTL track and Peter Wright's turnouts. Controlled by Tortoise motors on the bottom.
Controlled by Tortoise motors on the bottom, some turnouts are over framework and required 'offset' switch rod throws. I used same 0.025"...