If you are using the serial monitor (defaults to 115200), you may also want to reduce the speed at which this is operating (to 19200 ?) ... this...
On further consideration (and read some previous posts).... CMRInet uses a PC program to be the master ... this would then be problematic is the...
Gregg, If you car considering the RS485 solution, may I suggest using a CMRInet compatible syntax for you control message from the master to the...
Dave... I believe the main track power is connected to the "A" output. "B" output is the programming track. Give that a try ... can't hurt....
Using Gregg suggestion to revise the CURRENT_SAMPLE_MAX to 600 (from 300) solved issue of Motor Shield shutting down without notice. Able to...
Thanks for the suggestion ... I have an old engine and the motor draws a lot, and has poor contacts ... a candidate for an new can motor. Will...
so using a Motor Shield -- total amps = (value / 1023 )* 3.0303, where 3.0303 = 5/1.65 - for example = 338/1023 * 3.0303 = 1.001214 or 1.00...
On a slightly different note regarding Ethernet functionality and library setup of the INTERFACE ... would it be possible to use the a MQTT...
Yes C# ... also developing a DCC++ simulator so I can test software without actually talking to Base Controller.
Yes.. written in C# ... by a long time VB6/VB.net developer. Needed to convert for work, but some loyalties dead hard Once I get the client...
Got a very rough version of my DCC++ client working with Base Controller... all is working well -- very happy with Ardunio Mega AVR + Ardunio...
Earily version of DCC++ client working with BaseController
Gregg -- Great work!!! Got Base Station working using a MEGA AVR ... same but slightly different than MEGA. May want to allow this version when...
