I have uploaded a pair of loads: 115 ton pressure vessel load and a variety of wind turbine hub loads. 115 ton pressure vessel - this load is...
I don't know that FVM offers (offered?) plastic wheelsets. Regarding ER cars - I have a pile of their Autoflood II hoppers and after months of...
Maybe just a tiny bit... here's a few images: [ATTACH] [ATTACH] [ATTACH]
Fusion: very powerful program. I started using it years ago with my first design and the two designs I was working on yesterday were in... Fusion....
Evening all - figured I'd post a few designs that I have recently uploaded. First one is a 40m wind turbine blade, found here: 1:160 40m Wind...
Last few days have been mostly painting various items. [ATTACH]
I've not yet gotten around to painting the most recent 20' containers uploaded by @Stephane Savard so here's an image of one of the earlier...
Reworking those handrails is going to be fun... it's a beautiful model but there are a few hiccups like the electrical cabling between the front...
Due to the structural differences between the 40' and 48', it will be a challenge. It'd probably be easier to take the 53', cut the ends off, and...
As it sits this morning: finally got around to painting some all terrain cranes I printed early this year, a HEMTT will get into the paint queue...
Elegoo 8k space gray in a Saturn 2. Tried their water washable, didn't like it.
It may also be known as resin Kraft paper, which pretty much describes it: paper soaked in some sort of resin. Apparently it can be sourced in...
Unfortunately I don’t have a Canadian supplier. I mostly use laserboard of varying thicknesses from here: https://encompass-media.salesvu.com/...
From this morning, through the magnifying glass, annotated... taken whilst working on a pair of MTL 2003 for installation in a Kato SD70M. [ATTACH]
A while back I uploaded 3d printable turrets on Thingiverse: 1:160 N Scale turrets by samusi01 - Thingiverse which you may find to be of interest.
Perhaps it might be something to consider on the TrainBoard level to add a directory to the resource section listing folks with resin printers and...
Daily use, ex Frisco main over the Arkansas here in Tulsa. I cropped the original image: [ATTACH]
Not to hijack this too badly, but here's what I've done thus far, for a local who is working on an NTrak module. Here's an image of the original:...
Nice work. Eventually I'll have to figure out an easy way to do stone or concrete blocks in Fusion... my only attempt to date was far more work...
@railtwister Did you note @Joe D'Amato from Micro Trains responding a couple of days ago in this thread? Has he responded to any communication...