Just an update on my efforts to figure out what is going on with this shield. As I couldn’t get anywhere I ordered an original Arduino motor...
Hello, I got finally hold of the ACS712 for measuring current and hooked it up to the mega/fun dû moto combo but send the measurement to an uno...
Hello, thanks for the reply ok understood So i may try this for the time being just to see as i don't need main and programming at the same...
Thanks a lot for the reply and indeed i didn't check if the board has actually A0 and A1 as outputs :( my fault. Actually I am waiting for two of...
Again me, as I couldn't let go I finally got it working by changing in DCCpp.h SIGNAL_ENABLE_PIN_MAIN ( i tested this in the classic version )...
Hello, I am a bit at a loss now with my setup as of Diagnostics mode the programming part should work as the two LED's are flashing but the main...
Thanks a lot. Reading through the thread I went back to version 1.8.10 of the Arduino IDE and this worked. No crashes anymore. So for Mac Users...
Hello again, The first one i figured out. You have to add monitor_flags = --echo to the platformio.ini file! So my platform.ini file looks like...
Hello, I have successfully downloaded DCCppEX into my Mega but have issues using the SerialMonitor from PlatformIO. Actually the boot string...
My platformio.ini looks like this now: [platformio] src_dir = DCCppEX [env:atmelavr] platform=atmelavr board=megaatmega2560 framework=arduino...
Thanks a lot! As I couldn't figure out where to change the serial monitor baud rate to 115200 I changed the value in CommInterfaceSerial.h to 9600...
I am blind sorry ignore my question about the #ifdef ENABLE_LDC I found it in the Config.h
Hello, I am completely new here so maybe things i ask for are already written up somewhere please point me then to the right documentation....
