Thanks for getting back to me. I did try changing the address to the accessory address as you posted on the other thread. I was able to see the...
Thanks for getting back to me on this. I am using the 44915 decoder on it. I am able to control it like a loco using the throttle panel when it...
A little side track here, FlightRisk. We can PM if you don't want to mess this thread. About this accessory addressing. I've been searching for a...
Changing the addresses to 255 and onwards did not work. Still hunting for a long term solution.
I did see that. Don't that is the issue I have. Here is an update since last night. My head has been spinning and found a short term solution to...
I figured out the rays showing not connected. That's just because I did not have any track connected to it. Once I connected the track, it shows...
Has anyone setup a DCC Bachmann Turntable using JMRI? Tried running it yesterday, and it seem not be doing anything. Not sure if I have the layout...
I would to config my DR4018 to be able to control 4x snap turnouts, 2x LED(Green/Red), and 2 motor turnouts. Currently I am running it as default...
I got my DCC++ up and running pretty quick. Was an easy build. Instead of jumpers, I just soldered the pair of wires on the bottom side of the...
OK, will try that. Was not sure if I wanted to play with that feature, as i left everything stock. It is currently using the curve.
My DCC bachmann seems to running pretty much the same speed anything above poistion45 on JMRI.My bachmann seems to running pretty much the same...
Thanks. I was able to check out the pics.
Pretty sure they are bulbs, as these are really old coaches which I bought from someone. Should I be looking into swapping the bulbs to LEDs?...
I just started running a DCC layout using DCC++. Have a new Bachmann DCC Soundtraxx engine pulling a few rolling cars. I have a few DC coaches...
New to the railroad modeling. So started out with DC for a month and now jumped into DCC++ a couple a weeks ago. Was simple enough to configure....
Hmm, it said they are on backorder but I received an email it is being shipped today. Cool.
Nice. Much cheaper than what I saw on ebay and other sites.
Thanks. Will make sure I use a diff power source. Now, just waiting for some kind of sale to see if the price for that goes down.
I'm starting to build-up a track which I can use a non-DCC bachmann turnouts along with a DCC++ basestation. Is there a board which I can...
I am new to this too. But I don't think changing the wires on the track will change the directions of the loco. Does the direction change when you...