Hi there, Did you try this, what were the results?
Ok, With the higher voltage I think I fried the original 600R Zimo chip. I am running the software from the link...
OK, Bachman chip arrived this morning. Fitted this in after removing the Zimo and still nothing. At that point really scratching my head, I went...
Thanks all. I tried with the files from the link but still no read 308 and also no jerking from the loco. I have voltage to the dcc unit on the...
Evening all, So tried with voltages upto 18v No change, still get no acknowledge from loco (308) I do get current sensing if I apply a load...
Ok, Tried with voltages upto 18v. I get the same, albeit bigger jerks from the loco when reading the values. I put a load resistor on the...
Ok, great feedback guys, I will check with a 13v supply and feed back, have one of these from days gone by..
I have a 12v 1.5 amp supply, The Zimo is only a few months old (I think) mx600R Does the current sensing work on your board, even with a load...
THanks for the feedback, Any ideas why the one I have will not program a Zimo? I have a Farish chip raring in the next days..
Evening all, Please can anyone advise if this shield is any good for dcc++ I would appreciate it if someone can feedback before I buy another...
Thanks for the quick response Picture below? Hoping this helps [ATTACH]
Good evening, I have the Arduinomega and the Derek robot motor shield. Link from 13 to 2 I have converted a Farish Dcc ready with a Zimo 600r. I...
Hi there, New to N gauge and dcc. I have built a dcc++ Looking for help in making this work. Site looks really good so hoping I can contribute too
