Has anyone tried an Athearn FP45 shell on a Kato SDF40 mechanism? I have a couple bought off Ebay that I cannot get to run reliably at all. I'm...
I have some Walthers well cars that require some touch up. Has anyone found a good paint match for the TTX yellow? The only caveat is that I...
I had this same problem with the Digitrax decoder. I gave up and switched to the comparable TCS decoder. Problem solved. Jim
FWIW, I figured that I'd sell off some of my "extra" Kato Dash 9s with the arrival of the Atlas Dash 8s. No longer. I'll keep my 2 C40-8s, but I...
John, I will second a visit to Lowell NHP. I am biased, though. My father, Jim, is one of the trolley Motormen. Jim (Jr.)
Gary, I, too, have installed a TCS CN-GP in a LL GP60 per their intsructions. Everything seemed to fit fine, and the loco runs with no...
Expand the minimum radius Jamie, I recently dismantled a helix built with the curve radius right at 18". My C44-9s and Sd70MACs were...
Mike (et al), TCS will decide to either repair the decoder or replace it. They will do one or the other. The end result is that the customer...
Good day all, I have a Digitrax radio system, and I'd like some input on rechargeable batteries. Have people had good luck with them? Are...
Thanks for the replies, men. Everything turned out ok with the sets, as I didn't add any additional lighting to the cars. Jim
Merry Christmas. I wish each of you health and happiness for the coming year. Jim
I am about to switch my layout over to dcc, and I'd like to know if I must do anything "special" to my N scale Kato Super Chief and CZ sets with...
Thanks, Jim. I'll start with those suggestions...should keep me busy this summer.
Thank you, Rob. And I couldn't agree more with your first statement, as well as Wyatt's. Jim
Granted. What then is the proper Fox Valley axle length for use in Atlas trucks with Accumate-liscensed, albeit Atlas-manufactured couplers? Jim
Well, I had hoped for a quick and easy way to bang out those projects. So I naturally expected precisely the answer I received! Thanks Gary....
Does anyone know if old Atlas/Kato SD7 and GP35 motor, drive, etc. will fit into the new DCC-ready frames? I just thought of this, and it might...
Hi all, I recently moved to southern NH, and I'm looking for some tips. I know the ST runs up here, as well as the NHN. Other than Amtrak...
Well, the MT conversion wheels are clearly labeled, but which axle length do I purchase to replace Atlas wheels in Accumate trucks? I've seen it...
I teach 5th Grade. Jim B