Hi Folks This maybe common knowledge already but digikey electronics and probably many other sell a series of hand held cases that could be very...
Hi folks, I have just about completed building my DCC++ system using a Wesmos AT Mega with the wifi chip onboard and the arduino motor shield...
Thankyou very much
Hi Dave, long time, no chat. I have just followed your advice and purchased the WesMos mega 2560 with the onboard wireles chip. There seems to...
Hi Guys, I have recently purchased a WeMos AT Mega with the wifi onboard ( see image ) and was wondering if anyone had used one of these with the...
Thanks Dave You are indeed a champion, looking forward to the weekend. Regards marty62
Hi Dave I have been trolling around on the internet trying to find out how to wire the ESP8266 to the Arduino Mega. Some sites show a straight...
Hi Dave I actually do have the mega 2650 with the version 3 motor shield on top. The Uno was the original with the version 1 motor shield. These...
Hi Dave I actually ordered 2 x ESP8266 ESP-01 Wifi Modules, why 2 you may ask, well they were a package and cost me $ 6.00 AUS. It nearly cost...
Hi DaveT I actually live in a small country town about 30 mins from Wangaratta. Wangaratta is about an hours drive from Albury. I dont know if...
Thanks Jimbo20 It seems there was an error when I added the Motor shield in that the patch lead should have been between pins 13 and pin 2. I only...
Thanks Dave, this has been fixed thanks to your advice.
Hi Bill Another possible option is to use light transporters which attach to the original board led and are fibre optic so they transfer the...
Thanks Heaps Bill, some serious food for thought. The whole intent was to present what leds were active and operating, to the outside of the case,...
Hi Guys and Girls I have put together and Arduino Mega and the motor shield as required for DCC++. I have mounted all the pieces into a proper...
Hi Guys Firstly let me apologise in advance if this is a rookie mistake. ( I am down under in Australia after all!!) I have been following Greg...