@Ash big thanks for that, it helped to open the knot in my brain... (y) @haba thanks for the hint to "MotorDrivers.h" so let me resume, and...
many thanks for the quick response, but may be I was misunderstood! In the original version is a file "DCCpp_Uno.h" and in here are the...
I hope this is the right place to ask, as there are some other DCC-EX threads: I would like to know where in DCC-EX the pins are declared. In...
update: I now sorted out the compiler problem. It was a python issue! My os has two versions of that interpreter 2.7.17 and 3.8.1 but the...
I have got the PoluluShield now and it works fine but reading CVs from that Piko-Loco is not possible. So now I have four possible combination...
Hi Wil, today I got an answer from Piko, but they have no solution to it, because they don't know dcc++/JMRI ...(n) I soon will try a Polulu...
@Shdwdrgn thanks for the schematic! Although I want to use an Arduino Motorshield or maybe a Polulo MC33926 Motor Driver Shield it helps very much...
thanks for your quick answer ... it seems rather difficult to get the mentioned board. Is there a "general" pin mapping ( I found some info in...
Hi, some help for a good starting point needed! Trying to jump in here for an ESP32CommandStaion, going through the thread from the beginnig but...
thanks wvgca for the hint to look at "current sense" !!! The brandnew Arduino Motorshield was not properly soldered !!! There is an OpAmp IC on...
Hi, I have had problems in reading D+H CV's on the Prog-Track, but with the files of Felix it worked nice so far. Now the problem is back with a...
hi, this is only a compiler warning, and with the version 1.8.3 of the Arduino IDE it runs fine on an UNO, so simply ignoring the warning should...
Hello all, Hi dompondaco, I have just setup my dcc++ BaseStation with an Uno/ArduinoMotorShield (both genuine). The first problem was a faulty...
Today I made it to "TrainBoard" :-) I run a little n-scale layout since 2010, now sweeping to "digital". I found that really amazing dcc++...
