thanks RCMan that's what is showing finally. brendanf, thanks i fumbled around and got it loaded, so <1> turns led's on <0> turns them off for...
well i am wrong, i had base station on the Mega, it blinked rapidly and showed that it was there. the sketch page showed it went to the Mega...
ok, i got the basestation onto the mega. when i connect the motor shield to set the baud rate i do not have 115000 listed only 115200. all 4...
brendenf, thank you for your help. it is 6:40 AM here, i will try again to download in a little while. VaBEast, that would be great, my forgetter...
hi brendanf, the instructions from help said the zip would open automatically, so no i didn't unzip. yes i have the Basestation-master.zip and...
at the Arduino.cc help it says to be sure the blink sketch works to start with, then modify the delay to make sure the interface works, it does....
also when i click properties on a download i get windows blocked content. what's up with that?
i have connected the mega and the blink works, i can change the values to make the led change. what i am trying to do is get the base station and...
hi Max, i clicked on your link. i have looked at, i think, all the posts there, wow a lot. did not see what i was asking. maybe too dumb to find...
thanks guys, i can tear apart and repair most any vehicle or semi truck but cannot wrap my head around this stuff.
hi all, i am new on here and new to Dcc++. the Adm. suggested i post here. how do i move the base station and controller downloads from GitHub...
hi, name is Willis, i am trying to setup a mega 2650 and motor schield with the Dcc++ program that Gregg created. i have found on Github 2...
