Thank-you - I have just found a comment in the DCC++ code which states that DCC++ does not support ethernet on a UNO. - so maybe my question...
Can someone please confirm that the Pololu driver board is compatible with using an Arduino Ethernet Board on a Uno host Thank-you
I was very reluctant to use one of the Mega hardware serial ports - I need them for interrupts from track sensors - but I think you are correct in...
I have no connections to pins 0 or 1 on the mega - my problem is that I have to use pins 0 and 1 for softserial input to the Uno, and the evidence...
This is probably an Arduino issue rather than a DCC++ issue, but I hope some one will know what is happening! I am convinced I am doing something...
I see the last entry is dated Dec 22 2016 so ... May I ask What is the status of this project, and has anyone set up a system using these ideas?...
Brilliant, I had not realised that I can use Hardware serial to connect to a software serial. Thank-you for your help, much appreciated
Now I am confused! The uno (running dcc++ base station) is to be connected to the mega - and all serial I/O will be to the mega. So the uno will...
Yes using software serial is not a problem - my question was about the software serial overhead (using change level interrupts) impacting the DCC...
Hello Steve, Yes indeed - BUT pins 14,15,16 are all blocked by the shield I use to mount the TouchScreen, and I have to use 2,3,18 and 19 for...
OK thank-you for your question, here goes. I am using the Mega as a autonomous interrupt driven DCC command generator, (driving a DCC++...
Replacing (hardware) Serial with Software serial. I am looking to drive the Base station (on an arduino uno) from an arduino mega - using...
A TCCS (from Tec4Trains) decoder has two addresses (A) to drive the loco and (B) to operate the dcc driven coupler. With DCC++ Base Controller I...
Problem solved - mea culpa - I had somehow 'edited' my copy of the Base Station. David
I can run a train using a Mega/Pololu Base Station but the Controller does give me some problems (I have reinstalled, it from the download,...
I can build and run DCCpp_UNO using Xcode (with the Arduino embed extension) for a UNO board I can also build/run it using the Arduino IDE on a...
PS I was about to embark on modifying the controller to suit my objectives. But I am having second thoughts. If I have to reinstall a copy every...
Thank you all - downloaded and installed a new copy everything OK - seems like there is a bug in there waiting to be discovered.
Thank-you - but neither 's' or '?' do anything, nor does any other key press or button hit! I can only exit the Controller (top left red button).
I unwittingly asked the Controller to search for an Ethernet Port - but as I am running the Base Station on a Uno this was a bit of a mistake....