Blame us of what exactly? I dare say that DCC-EX has done more for the "uninitated" to get a DIY CS with open source code up and running than any...
Find the right branch on github and finish the port if you fancy the ESP8266 so much. I however did not find it worth to do the ESP8266 port as...
I always ask: What Decoder? Decoders can expect that speed information is sent continiously and if they discover that for some time no speed info...
Well, I have seen contradicting informaton if the RX can cope with 5V not not. I have so far run the GPIO pins (to enable and to flash) at max...
To define an own motorshield do like this: 1. Copy the standard motorshield definition from MotorDrivers.h to config.h (in front of the...
There will be a relase "soonish" of Commandstation-EX and the Basestation(s) are history. Regards, Harald.
The volatile has been put in. Thanks for finding and the excellent report. I am not that good in analyzing compiler optimizations to decide if the...
That 1.5K at the input is designed so that you never exceed 20mA to the 6N137, even if you feed it with 25V. But if you have a lower voltage DCC...
I have investigated the MC33926 board with different Versions of DCC++ (Classic, EX, Asbelos, mine(*)). The answer is that 60mA is below where the...
At this stage I would recommend to use DCC++EX https://dcc-ex.github.io/ or my fork dcc-ardu, not the DCC++ original as it has many problems in...
Yes, I agree, PROG track must be possible to limit to 250mA. But the limit does not need to be in hardware?! It's easier to make the limit in...
I guess we are on ms and mA on the axis. Why are there 2 series and both series look smoothed. Can you plot pin reading and smoothed value? I...
I have a finger injury so I will keep it short. For the current sensing the orig code is nonsense, because if you do nor immidiately sense after...
The "turn on again after short" feature is something that people will want different for differnt situations. Think of layouts from Z to G scale...
#defines are expanded before compile and do not safe space in itself because it's expanded to several strings again. Compare the following two...
What JMRI expects today can be found there: https://github.com/JMRI/JMRI/blob/master/java/src/jmri/jmrix/dccpp/DCCppConstants.java There you find...
But one does not need to allocate a 256 bytes buffer to print status messages. One does not need always to reserve space for 10 (if I saw that...
You wrote: <F> command f6400 Ok, that's on a Mega which has 6*1024=6144 bytes more RAM than the UNO. So if we do 6400-6144 then the same number...
Just to clarify, the code "as is" did not break the bootloader, I did first add some debugging statements. Then it went unhappy with verify flash...
Ehm, I think there are dangerous waters around here. I just tested the current DCC++-EX git-master sketch on my UNO. That did not work, as...