Hi Mike, the EzSBC esp32 modules are definitely toast, the shield over the wroom-32 module gets pretty hot when a supply is connected. I've...
I've managed to get everything running, ... but at a cost ... I ended up frying two EzSBC-esp32 modules via the IBT-2 H-bridge's R_IS pin sitting...
Hello Mike, Norm and esfeld: I've managed to get the display working with v1.2.2, although I get the following message on an esp32 reset: .......
Thanks for the prompt response Mike and esfeld. I've tried swapping the Rx and Tx, also swapped the pins def's 14 and 27 in Config_Nextion.h...
Hello Mike, I've installed your version 1.2.0 (on a new ESP32 EzSBC board) and must admit you have added a tremendous amount of flexibility to...
Further to my comment on the ESP-NOW use for wire-less hand-held throttles, ESP-NOW uses WiFi but does not need the local network (direct link...
Hello Mike, was checking today for possible reasons the loco numbers were not updating on new downloads to the ESP32. I ended up commenting out...
Ooops, spoke to early, back to not being able to change loco address (just that one time). Tried changing code (actually info text to serial...
Hi Mike, thanks for the prompt response. Went back and checked if AsyncTCP library was installed (listed) in Platformio, and it wasn't (although...
Hello Mike, back again (as expected...), while trying to figure this all out, something went wrong and I was getting ASyncTCP.h error messages...
Thank-you Mike for your quick response, the project now builds without errors. Onto up-loading to the ESP32.... I'm sure I'll be back with more...
Hello, first I would like to thank you for your work with DCC++ on the ESP32. I'm not able to build the project due to PIO not finding the...
Hello All, I should have realized the Arduino pin 10 output (16 on the ATmega328 chip) was not working (output toggling between 4.5 and 5V, not 0...
Thanks for the prompt replies Scott, Atani and Jirka. I'm using the Arduino Motor Shield (with the Vin and Brake jumpers cut on the back). Both...
Hello, I'm new to DCC++ (with a bit of DCC and Arduino knowledge). I've set up an Arduino Uno with Arduino motor shield and have been able to...
Greetings from Montreal, Canada. I've been a modeler for quite some time now, although I took a break for most of my 30's-50's, now that I have...