The MakerFab ESP 8266 WiFi Shield uses the 5vdc pin from the Arduino for power, reduces it to 3.3vdc and feeds the ESP processors vcc in.
Welcome to the Open Source DIY World of DCC++EX, Congratulations on successfully building a DCC++EX Mega & WiFi Command Station and getting...
My pleasure, Best when viewed & used through a Web Browser. It was written for my local SCMRRC members for our DCC++EX & DecoderPro Clinic not...
Enjoy!
Hi Ted, and for all Other DCC++ Users There are many reasons why you may be having trouble and many way to solve the issues. Start from what we...
see response below
Hello Ted, Welcome to the friendly world of DCC and thank you for taking the time to explore DCC++EX. Yes, DCC++EX Programming track is Highly...
Thank you Bruce, Your Traffic Monitor show this decoder is not responding with any milAmps max=0mA and is not talking back at any length of time...
Hi Ash, This is good information for us and for more experienced DCC++EX users. But this Thread is Labeled "New to DCC++" and I was trying to...
Ignore the 'unknown' response it is a glitch on the JMRI vocabulary that is being corrected in 3.0.10 available for download now. We're...
Yes, I noticed it after I posted. Thx. Usually the DC voltage drops 1v to the track so I would expect a 12.5 vdc input to be abt 11.5vac on the...
Hi Bruce. OK, Actually this might be a Good thing. I'm assuming this is your correct configuration Mega2560 L298P Motor Shield 14.5v on the...
Bruce, If your running DCC++EX3.0, Before you give up on reading CV's on the 4th Loco try upgrading to the DCC++EX 3.0.7 Development release and...
Yes, you would Wire the B cab from the Arduino Motor Shield to the insulated Programming Track and the A cab wires from the Arduino Motor Shield...
ScottyB, We've pulled this Thread information over to DCC++EX Support on Discord server and are taking a closer look at it. Please give us some...
wvgca, Short answer is #5 for a competent DCC++ JMRI Decoder Pro user. If ,Then, Else a #3 for a non-competent DCC++ JMRI Decoder Pro user....
Thanks Steve, I was inspired by your previous posts on flashing the ESP chip. I'm also looking forward to the DCC++EX enhancements particularly...
Roby, Success with ATMega2560+ESP8266 WiFI combo board with DCC++EX 3.0.0 Standalone WiFi Command Station. My Current Config: DCC++EX 3.0.0...
Jack, I'm in the process of trying a Wemos Mega Wifi & ESP8266 with DCC++EX 2.1.1 and Dave's ESP8266+DCC sketch. I loaded the DCC++EX Mega with...
All good, Vote for 4: 1. D is slanted, 2 & 3 D looks like an O. K