Steve, I used the FTDI interface mentioned on Daves web page (another package from china). The Arduino serial monitor was purely to see what was...
Steve, I followed Daves webpage on the HC-12. Where it talks about connecting the SET pin to ground to enable the configuration process, I...
Dave, I have successfully got the BTS7960B 43A H-Bridge option working on an Arduino Mega after a bit of head scratching. On your web site on...
Dave, I have successfully built two wireless throttles with rotary encoders and they communicate with the DCC++ base which I can see on the serial...
MarklinLA, Oh YES , its model railroading alright. At intelligent prices. The BIG difference is the cost of DCC++ compared to any other system....
And some would like the DCC++ base station to be able to get its commands from a Loconet bus :). But I have so much back yard railway civil...
Hi, After a few distractions I have got back to the fun of getting DCC++ to operate on my outdoor G railway. First hold up was that I had my...
HI Gregg, Step two, the jumpers on the Arduino motor shield for the Mega. The paragraph in the BRIEF NOTES ON THE THEORY AND OPERATION OF...
Hi Gregg, This is good for a laugh.................. I have just got the sketch to upload to my Mega1280. I tried your suggestion of removing the...
Hi Gregg, Your response is much appreciated. I downloaded the latest Zip file from Github and unzipped it. Using Arduino IDE 1.6.4 I set up the...
HI, Today is a good news and a bad news day.... Good news..... Arduino motor shield arrived in the letterbox. Bad news.... #error CANNOT...
Hi everybody, An introduction from a lurker in the shadows. I had a "G" (45mm) lay out running in my back garden using DCC with LocoIO hardware...
