It seems that NZ Ross and I got keypads from the same factory build. As noted in posts #191 and 193, all keypads are not the same. I changed my...
Dave, Thanks Dave. I just did that and got the display. Now having some problems setting loco addresses. May have a problem with the number...
Did that and updated the code in one place.
Hi Dave, Thanks for everything you are doing for this great DCC++ community. My hardware skills are fairly good , but software/coding leaves a...
Steve, I'm one of the lurkers and have been reading every post you have made. I am just learning a lot of this - my first experience with DCC....
I tried writing a couple long addresses sing the Long area under Engine Addresses - "Error - Writing First Byte of Long Address Failed". Didn't...
Hi Gregg, I tried to write to CV 17 directly and got a write error. So back to Google search. One suggestion was to insure that CV 29 bit 5 was...
Yes Gregg. I can read and write to all the CV's above and CV 30 is 0. I presently have CV 29 set to 2 (no DC function). I was under the...
Mike, Yes the loco pulses. I have had no problem writing CV's on the programming track except the Loco Address. As you suggested, I did change...
Gregg, Thanks for the prompt reply. I had not tried running the locomotive with the base station since the JMRI throttle seemed to work. I can...
My system: Arduino UNO R3 original – Pololu Motor Shield – 20V 3.3 Amp laptop power supply regulated down to 16.75 V DC. DCC++ output to the...
Dave, You continue to amaze me. (As do so many other of you working on Gregg's "invention"). Outstanding contribution! David U
Just did that and I'm the second responder. I think it is a great idea. I'm reluctant to ask questions to the present forum. You folks are so...
I agree. I'm one of the newbies to DCC and need all the help I can get with many things. The DCC++ forum has been a great help, but the activity...
Kevin, You obviously are much more advanced in DCC than I. From my beginnings I have two suggestions. Think about getting the Pololu motor shield...
Thank You! Really helps. David
Gregg, You are indeed unbelievable! I'm sure you will be happy when folks like me are not bothering you with our problems. The new diagnostics...
Gregg, Here is an update. I decided to get a new genuine Arduino Uno and redo the shield for it according to your directions. Now I have power...
Hi Gregg, Yes, the system was working before I changed to the new supply, but the voltage was too high with a 20 V input to the Pololu. The...
Gregg, et al., Having problems. You may recall that I was concerned about my power supply having excess voltage. I ordered a LM338T regulator and...
