I was just going by what I was told from someone at Kato USA. They thought the Mikado light board was the same, good to know that's not the case...
Hey everyone I thought I'd give an update on this project. I picked up a new dz123 and wired it all up again after milling some more areas off the...
Paul, so are you saying this is how it should have been wired: [IMG]
The next few pics show everything as it was installed: [IMG] [IMG] [IMG] [IMG] [IMG] Here is the rear: [IMG] Front: [IMG] This photo shows a...
Ok so I had some time to take some pictures of the install last night. I should start this post by saying that I think the decoder is friend. It...
https://vimeo.com/114194124 Ok figured out how to posts video. This is what is happening on the track.
Ok so I've tested everything with a 9 volt battery and everything works. I wired everything back up and put the battery leads to each side and the...
I really appreciate all the help guys. I've done almost all the steps you've suggested-ground out slots in the frame to run the motor wires, used...
Ok I tried the installation today and when I put it on my track and turned track power on the power automatically trips off. No smoke or burning...
Just one question though, what's the best way to isolate the motor?
Thanks for the feedback on this guys. I've done some research and feel fairly confident I can mill the frame and install a dz123 by myself. I...
I am new to N scale and trying to install my first dcc decoder (I have done many dcc decoders in HO scale). I thought I ordered the Digitrax...
Hey everyone, I am hoping you can help me with a problem I am having. This week I installed my first ever Soundtraxx Tsunami decoder into a...
