Paint the entire building with a spray can that is the color you want the trim, then just paint the brick over this "primer" coat with the brick...
Not yet, the turnout is just so close, the frog only moves about 1/8" and the tolerances are just really tight. Some locos handle it better than...
Nine more #4 turnouts? I hope your not a drinking man. I only have one and it gives me fits compared to the six #6 turnouts.
I had a fried Zephyr Xtra that I just received new two weeks ago. Sent it this week to Digitrax and got a note today to allow 30 business days...
I have made a few more revisions to the track plan to extend the track and put in a viaduct on the left for cars to pass under the train track to...
Thanks everyone, looks like its unanimous for TCS!
I am looking to buy a 3 engines to pull my California Zephyr car set I got for Christmas. I have not setup a DCC system, but plan to use the...
Thanks for the idea Poppy and Dave. I lengthen the layout by two straight tracks, but left the curves the same as the 36" width is a hard...
Thanks, I think two DS64 will control the seven turnouts and the double crossover. How do the decoders report back the position of the turnout?
Thanks, one more question. When you control turnouts with DCC vs. the manual switch like Kato sells, how do you determine the active position of...
Planning my first N layout with Kato Unitrack and planning on using DigiTrax Zephr for control. For DCC wiring, do you ignore the pre-wired...
Thanks for the suggestions, I will try and bump the radius up one more notch and see if it will fit in my area. I am not restricting myself to...
This is my first attempt to create a layout with XTrackCAD. I started with the Kato Amherst 2005 layout and scaled it up to get rid of all the...
I am new to this board and completely new to model railroading. I have had a lot of hobbies over the years including 30 years of building RC...
