nice jOb, congratulations!
i used atlas number six custom line turnouts on my layout, and although they had the capability of powering the frogs, i left them dead with no...
in all likely hood they would be hard wire installations, so the decoder wouldn't matter much
you will still need resistors on any of the supply rails .. white leds are only 3 volt [max], and other colours are less
merg is an excellent resource for diy / home made projects ...i based a decoder [non sound] on one of their projects, and it worked to ten dollars...
the file that you linked to on thingiverse gas both N scale and HO scale STLs avaiaible .in the ZIP file
it didn't hurt mine, but i only had it hooked up to DC for maybe a half hour , then i disconnected the the reverser, i hooked it up again when i...
if the auto reversers are MRC, they will just click and not work ... i don't have any direct experience with other brands
i made mine on a brother colour inkjet printer ... cost was 10 bucks for six sheets of decal paper [8 1/2 x 11]] .. so far i have used a third...
depends on what type of printer it was made on [resin or filament] ... if you are not sure a bit of a wash in bestine or alcohol would work okay...
a command 2000 does not have the ability to read back cv's
semi interested ... i have an older prusa clone filament printer , and a small assortment of filaments ..heated bed and auto zero ... would only...
i -sometimes- use DCC++ , but i use the JMRI console, no seperate throttle ..
Hocritter1 by wvgca posted Nov 29, 2022 at 1:18 PM it would be a fair bit of work to add power pickups to the front of that, but in this case it...
i have one but have not noticed a dropping of power in any frog ... does yours loose power on just one frog, and pretty well every one ??
i still like my hakko 936 station, bit more money, but in my opinion, worth it
is the op talking about trammels ??
when i used to do installs, i found that the Lais brand was quite reasonable, i never had one go bad on me anyways ...
very nice work, and especially since it was pretty much all scratch built in such a tiny scale .. i do have a model of the igersoll rand boxcab in...
the pager motors that i used were 3.50 for ten off ebay [including shipping], and the thread was gutermann silk from walmart, a little over a...
