National transportation Safety Board synopsis
Quando Omni Flunkus Moritati
View Tag Cloud
Sorry this is a little long.
This post is directed at those of you who speak Japanese and hang out at Japanese modeling sites. Maybe you could make a post for me and see if anyone responds.
Yup. Even if possible, it would be a major chore.
Same here. I built two modules using Unitrack, then switched to using my stock of Atlas flex and Peco switches. Works just fine. I only use the Kato at module ends.
This looks and sounds wonderful. I have two of these in B&O, but they run fast in dc.
How does adding a decoder effect performance and speed?
I am tempted to have decoders installed, but only...
If you are old enough to have a first born, then your kidney's are only worth $24.95. Depreciation and age effects the cost of everything...
I got too excited when I found a related web site and managed to break a tab off the Malletís motor. I was in the process of wiring the rectifier, motor control, and tachometer sensor in the engine....
Take Advantage of Opportunity
That's the theme of this blog. Take advantage of opportunity.
Once again, it's been some time since I've written a blog. For that matter it had been some time...
Some people cannot see the pictures in my previous blog posts. So here they are:
>$5 DRV8801 Motor Driver:
The development version of the hardware is almost ready to be connected up and tested. I thought it would be good to make some preliminary documentation available. You can find PDF versions of the...
I have just uploaded a couple of photos of my first module. Its a basic 210mm by 30mm standard box type. The fence, track filler across the track and gates are 3D printed, I have one at home. ...